Aluminum Can Crusher Equipment is also known as metal crusher, iron scraper crusher, paint bucket crusher, can granulator, etc., that is to say, can crusher can simultaneously crush iron scraps, paint buckets, iron sheets, circuit boards and Other metal materials.
Metal crusher is mainly used to realize the decomposition and crushing of large mouth waste metal, and to realize the fine crushing of waste metal, so as to achieve a better benefit prospect in the transportation cost and recovery price of waste metal. This series of equipment is a kind of multi-purpose and high efficiency metal kneading ball equipment produced by our factory. it can be used to achieve good paint removal effect and granulation effect whether it is used in end-of-life cars or waste cans. In the working principle of the equipment, the metal pulverizer makes use of the basic principle of the hammer strike, under the drive of the high speed and high torque motor, the hammer head on the rotor of the main engine takes turns hitting the material to be broken into the cavity, through the space formed between the liner plate and the hammer head, Tear the debris to be broken into pieces in accordance with the specifications. According to the working condition of the crusher, it can be divided into dry system, wet system and semi-wet system. Dry system mainly means that the broken material must pass through the air rotary sorting system to separate the metal and non-metal, in addition, the whole system is equipped with dust removal device. Wet system is to spray water at the same time of crushing, and to wash with water at the same time of sorting. The semi-wet system only carries out a small amount of water spraying when the crushing needs, to prevent dust, and there is no cleaning. As a high quality equipment for scrap metal crushing treatment, metal crusher can greatly improve the disassembly efficiency of waste metal in terms of investment value, and at the same time enhance the purity of waste iron and steel to provide high quality burden for low cost smelting of scrap metallurgy industry.
Metal crusher series products mainly include: easy to pull can grinding, color steel tile crushing, scrap car crushing, paint barrel crushing, iron chip crushing and other series of products can be used for a variety of waste metal recycling crushing processing.
In the working flow, the metal pressing block is fed into the forced feeding and crushing port of the equipment through the feeding device, and the metal pressing block is primary broken by the crushing process of the pressing roller and the coarse crushing shaft, The metal pressing material after primary crushing enters the main engine cavity of the equipment, and under the drive of a high speed and high torque motor, the hammer head on the rotor of the main engine takes turns hitting the metal pressing material entering the main engine cavity through the space between the lining plate and the hammer head, When the crushing block can be fully and effectively broken in the crushing chamber, the crushing block can be torn into a fragment in accordance with the specifications, and then flow down from the screen. The broken material is separated by an air rotary sorting system, and the paint, rust and waste plastic in the metal press block are separated, and the material unloaded at the bottom of the equipment is then transported to the aggregate point through the conveying equipment, In this process, the non-magnetic materials contained in the materials are separated and unloaded from the production line to the non-magnetic materials pile under the action of the magnetic separator.
In addition, the whole system is equipped with dust removal device to minimize the harm of dust pollution in the production process. The equipment mainly has the advantages of high output, low energy consumption, high efficiency, uniform discharge and so on. When the equipment is used, the noise is low, there is no pollution, the operation is simple and the maintenance is convenient.
(1) selection of equipment type.
(2) Design and manufacture products according to the special requirements of customers.
(3) training of technical personnel for clients.
(4) The company plans the site for the user free of charge, designs the suitable process and the plan.
(1) acceptance of the product.
(2) assisting clients in the preparation of construction plans.
(1) assign special after-sales service personnel free of charge to guide customers to install and debug.
(2) installation and debugging of equipment.
(3) on-site training of operators.
(4) after the installation of the complete set of equipment, the full-time technical personnel may assist the customer in on-site production until the user is satisfied.